Skip to content

Use the GPIO pins on the Raspberry Pi without running as root

License

Unknown, MIT licenses found

Licenses found

Unknown
LICENSE.md
MIT
MIT_LICENSE.txt
Notifications You must be signed in to change notification settings

VipSaran/quick2wire-gpio-admin

 
 

Folders and files

NameName
Last commit message
Last commit date

Latest commit

 

History

56 Commits
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

Repository files navigation

GPIO Admin

A command-line tool to export or unexport the Raspberry Pi's GPIO pins and allow only the user to control then.

Installation

To install the gpio-admin command & manual page, and create the gpio group if it does not already exist, run the following commands from the root of the source tree:

make
sudo make install

To uninstall, run the command:

sudo make uninstall

Getting Started

To access the GPIO pins you must add yourself to the gpio group:

sudo adduser $USER gpio

Then log out and back in again. (Your membership of the gpio group won't take effect until you do.)

You can now export GPIO pins and use them without having to log in as root or use the sudo command.

% gpio-admin export 22
% cat /sys/devices/virtual/gpio/gpio22/value
0
% echo out > /sys/devices/virtual/gpio/gpio22/direction
% echo 1 > /sys/devices/virtual/gpio/gpio22/value

When finished with a pin, unexport it again:

% gpio-admin unexport 22

GPIO Pin Identifiers

The gpio-admin command works with the GPIO identifiers defined by the SOC, not Raspberry Pi header pin numbers or the GPIO numbers assigned to header pins by the Raspberry Pi documentation.

The example above uses SOC GPIO 22, which corresponds to header pin 8 on the Raspberry Pi, and that pin is named GPIO 3 in the Raspberry Pi documentation.

All very confusing!

We provide higher level APIs that map between the pin identifiers that users understand and the identifiers defined by the SOC, and use gpio-admin behind the scenes to export/unexport GPIO pins as required.

Enabling the Pi's Pull Up and Pull Down Resistors

The Pi supports pull up and pull down resistors for each GPIO pin. To enable this add either "pullup" or "pulldown" as a 3rd parameter. Assumming that pin 17 is floating:

% gpio-admin export 17 pullup
% cat /sys/class/gpio/gpio17/value
1
% gpio-admin unexport 17
% gpio-admin export 17 pulldown
% cat /sys/class/gpio/gpio17/value
0

More Information

Usage instructions are installed as a man page, and so can be read with the command:

man gpio-admin

Copyright & License

Copyright © 2012 Quick2Wire Ltd. http://quick2wire.com/

See LICENSE.md for license information.

About

Use the GPIO pins on the Raspberry Pi without running as root

Resources

License

Unknown, MIT licenses found

Licenses found

Unknown
LICENSE.md
MIT
MIT_LICENSE.txt

Stars

Watchers

Forks

Packages

No packages published

Languages

  • C 72.0%
  • Makefile 28.0%