Any luck on installing NeXTSTEP on v86? #933
-
|
Im trying to run NeXTSTEP 3.3 on v86. Setup starts without issue, however I seem to get stuck when it asks me which SCSI interface the CD drive is connected to. So if anyone has ran NeXTSTEP on v86 in the past, whats the procedure for doing so? my emulation config: CD: NeXTSTEP 3.3 ISO (m68k & i386) Also, is there any way to get more virtual floppy drives? Im wondering if the setup is hanging because I had to swap out boot disk for the driver disk during install. |
Beta Was this translation helpful? Give feedback.
Replies: 1 comment 3 replies
-
I tried installing NextSTEP 3.3 and OpenSTEP 4.2, but no luck.
However, there is a problem with *Step that they cannot be installed on new versions of QEMU (https://www.emaculation.com/forum/viewtopic.php?t=11469), so it will be difficult to debug :( |
Beta Was this translation helpful? Give feedback.
-
what's the last version of QEMU that STEP worked on? |
Beta Was this translation helpful? Give feedback.
-
|
personally I tested only QEMU 0.9 (see https://virtuallyfun.com/2017/04/22/darwin-0-1-rhapsody-dr-2-booted/ and https://gunkies.org/wiki/Installing_NeXTSTEP_on_Qemu#Configuring_Qemu) UPD: I found patch for QEMU 6.x, that fixes bug similar below: https://www.nextcomputers.org/forums/index.php?PHPSESSID=6e7144e491e68da54aef4cc22505c437&msg=27804 |
Beta Was this translation helpful? Give feedback.
-
|
UPD: I have installed Apple Rhapsody RP2 with enabled
I think that better create the issue about starting Darwin (NextStep, Rhapsody, OpenStep and etc) |
Beta Was this translation helpful? Give feedback.
I tried installing NextSTEP 3.3 and OpenSTEP 4.2, but no luck.
About NextSTEP 3.3, while installation I choosed
Primary/Secondary(Dual) EIDE and ATAPI Device Controllers (v3.35)(can be found on beta driver floppy). On starting system, I get cyclic error likehc0: ATA command c4 failed. Retrying...(and some errors about Floppy controller, but I disabled it)However, there is a problem with *Step that they cannot be installed on new versions of QEMU (https://www.emaculation.com/forum/viewtopic.php?t=11469), so it will be difficult to debug :(