Skip to content

ESPHome configuration for energy 6 channel CT clamp board. Used for energy monitoring 6 circuits.

Notifications You must be signed in to change notification settings

mcaminiti/esphome-energy6channel

Folders and files

NameName
Last commit message
Last commit date

Latest commit

 

History

15 Commits
 
 
 
 
 
 
 
 

Repository files navigation

esphome-energy6channel

ESPHome configuration and steps used to created energy montiroing boards using an ESP32 chip with a energy board capable of reading 6 CT Clamps across 6 circuits. Integration completed to Home Assistant using API from esphome.

Overview

ESPHome device was built using a video from digiblurDIY tutorial for guidance.

My process was modified as I run Home Assistant in a container and do not run Hass.io, therefore I ran esphome in a docker container using the script in my repo. I also had to tune / calibrate the Volts gain and amp gain to get correct calibration for my home. Be sure to perform USB flash initially as noted with the ESP32 chip not connected to the board.

Parts List

  • Split Core Current Transformers 100A/50ma (Note these were too small to fit around my main feeds. Recommend measuring or using the larger split core if planning to use on your main power feeds. Link
  • ESP32-S NodeMCU Link
  • 9VAC Power Supply(THIS IS AC NOT DC) - Link
  • CircuitSetup 6 Channel Board - Link

Config YAML

Docker Information

Docker - esphome/esphome:dev docker run -d -v "/LOCAL/PATH/esphome/config:/config" --net=host esphome/esphome:dev

Software

  • ESPHome Flasher - Used to flash initial config to ESP32. Used this utility on a Mac and it required extra drivers installed for serial to USB.
  • Drivers - Installed these drivers to make the Serial port show up when connecting as USB to Mac.

Calibration

I used a clamp meter on a custom built cord to allow me to place the CT clamp and the clamp meter on the same device. I used a 55 W Rough Service Incadescent bulb to tune the Volts by adjusting gain_voltage until it matched my house voltage. Then changed the gain for the amp readings to match the draw. I used the web page from the ESP device to view readings of amp/watts while tuning. Each clamp was calibrated but all in my set were the exact same settings.

Project Pictures

UI UI UI UI

About

ESPHome configuration for energy 6 channel CT clamp board. Used for energy monitoring 6 circuits.

Topics

Resources

Stars

Watchers

Forks

Releases

No releases published

Packages

No packages published